Dear forum members, I am restoring a Beogram 4002 and would appreciate some help with a platter motor speed issue. So far, I have done the following work:

• Relubricated the mechanical parts
• Re-infused the motor bearings with fresh oil
• Re-veneered the wooden trim
• Replaced the burned-out carriage motor H-bridge components
• Replaced electrolytic capacitors
• Replaced the 33/45 speed adjustment potentiometers with new 5 kΩ parts

The unit now works and looks almost perfect, but the platter motor speed is far too high. Current measured speeds:

• 33 RPM setting: around 55 RPM
• 45 RPM setting: around 67 RPM

Adjusting the speed potentiometers does not bring the speed anywhere close to correct. I have checked the motor feedback coils during reassembly, and checked them again today. Both measure around 18 Ω, so they appear to be intact. One strange observation: If I touch/bridge R18 or R19 to what I believe is ground — a large solder pad on the main board — using my finger, the platter speed drops. If I do this to both R18 and R19 at the same time, the speed drops even more. If I make the same bridge with metal, the motor stops completely. This makes me suspect that the speed control circuit is not receiving or processing the feedback signal correctly, but I am running out of ideas on where to look next. Could anyone suggest what I should test next? In particular, I would be grateful for advice on which transistors, resistors, capacitors, or IC pins in the platter motor speed control circuit are worth checking. Thanks in advance for any guidance.