What device are you trying to control with the A.MEM command?

BeoSound2500 Tape. CD, Radio and AUX works without any problems...

Guy wrote:

If you put the BL3500 in L.OPT 6 there should be no need to press AV first and you should be able to select your iPad using any video command (TV, SAT, DTV, DVD etc). This assumes that your iPad is connected to AAL input pins 3 and 5.

Thx - that's it :) I assumed that my BeoLab 3500 WAS in Option 6, but it turned out it wasn't. After activating Option 6 now iPad is seen as TV - by the way, is there any way to change this name? And what if I want to listen to iPad through Beosound 2500? My setup is a little bit messy now, because I'm new to B&O Masterlink. I have three zones: - zone 1 with Beosound 2500 connected to Masterlink via BeoLink Converter 1611 (the newer one with Audiomaster function), BeoLab 4500 speakers connected to this BeoSound 2500 and iMac G4, which I'm trying to connect to Masterlink via BeoPort

- zone 2 with BeoLab 2000

- zone 3 with BeoLab 3500 and iPad connected to Masterlink via BeoLink Converter 1611 (the older one)

Right now I'm able to listen:

- zone 1: Beosound (all sources + bluetooth + 3rd party TV via A.Aux, no sound from iMac)

- zone 2: Besosund 2500 (all sources), iPad from zone 3

- zone 3: Beosound 2500 (all sources), iPad, didn't try iMac yet (not enough Masterlink cables so far :) )

Will it be possible to listen to iPad from zone 3 on BeoSound in zone 1? Which source should it be? It can't be TV (like in zone 3 on BL3500) because choosing TV on BS2500 uses A.Aux. Is it possible to listen to a source from masterlink on BS2500 connected to masterlink via 1611?? Like this:  source -> ML -> 1611 -> BS2500 -> BL4500? Or is it only one way BS2500 -> 1611 -> ML -> any ML Speaker ?

Best regards

Adam