Location: Perth Western Australia
Beocord 5000 Type 49xx no sound
11 replies
Tape mechanism works but record/play relay fails to pick when play pressed, so no sound.
Have you opened the player up?
The record/playback relay should only draw when record is pressed.
Do the VU-meters react while playing a tape?
Martin
Thanks, Dillen.
From the circuit I thought RL101 needs to pick for play. No, nil display on VU's when recorded tape running.
Location: Perth Western Australia
Thanks, TJames for your reply. Yes, opened and replaced a number of darlingtons in circuit around RL101. No VU's on recorded tape. No change on micro pin 36 !REC.
Location: Perth Western Australia
Check the supply voltages to the Dolby ICs.
Particularly the Vref (a dead C2 wouldn't be a first).
Martin
Thanks, this deep electronics is daunting for an old bloke! But B&O have made any servicing a delight!
I will check voltages around the Dolby ICs.
And your suggestion of Vref will be done, too.
davidross
Location: Perth Western Australia
Sorry for delay in answering, Martin! Thanks for the leads.
Checked all voltages including 14a around Dolby board. All present. But worst possible result for fault - after reassembly it works perfectly!! Tested now with many tapes both in playback and record.
Guess I just wait for something to show up some day ... sigh
Location: Perth Western Australia
New thread: what is best solvent to remove the gunk left by perished belts in tape drive??
Location: Perth Western Australia
Please Log In to Reply
You must be logged in as a BeoWorld member to post replies to forum threads.
or![]()
Join BeoWorld
Register to access the forums, reference material, and exclusive member benefits — including our monthly prize draw.
Become a Member