I was given this beautiful table, had been stored away for years and took some work to get motor working and lubricated... now spins beautifully and does not throw belts. I then went to work on getting the cueing mechanism etc lubed and functioning as well.   That is where I got myself into trouble.  I must have installed the white plastic Cam Lifting Wheel incorrectly because it is no longer functioning as it should. If I turn it manually it will catch the small white gear, but then it goes back to the flat spot of the wheel and does not catch.   Does anyone have a picture of how it should be installed at rest? As it may be obvious from my post, I am not a skilled technician. In it's current state, it just spins and no switch has any effect on it.   It will spin until unplugged.  No arm movement, no lift, etc.