How to separate top and bottom of BG4000 platter

4 replies
YA
yachadm
Bronze
1415 posts
Posted June 14, 2022 at 08:31 GMT ? Edited May 11, 2024 at 08:38 GMT
#686287
Hi all I want to polish a BG4000 platter - that's the heavy one, with the stroboscope markings on the underside. I can't figure out how to SEPARATE the lightweight shiny top portion, from the heavy dull bottom portion, in order to remove the plastic ribs. BTW - This BG4000 platter is the identical platter found on the Early BG4002 models with the AC motor. Has anyone done this, or knows HOW to do this? Thanks Menahem Yachad Jerusalem

Location: Jerusalem

My B&O Icons:

Beoremote-Beo4.png Beoremote-Beo4.png
Beovox.png Beovox.png
Beomaster.png Beomaster.png
Beogram-400x.png Beogram-400x.png
Electronics Technician in Jerusalem Israel. B&O fan for over 50 years.
Mark-sf
Mark-sf
Bronze
592 posts
Posted June 15, 2022 at 04:05 GMT
#692368
I would not try as the two pieces are bonded. Applying heat to relax the bond would damage the ribs.
YA
yachadm
Bronze
1415 posts
Posted June 15, 2022 at 04:44 GMT
#692369
Mark thanks But my question is How to DO it, not "How NOT to do it". Obviously Direct heat would damage the plastic ribs. Mentioned here that a platter arrived separated after heavy handling in transit. https://beolover.blogspot.com/2018/03/beogram-4000-glueing-delaminated-platter.html So, it IS possible to separate them, but that method I would not try. Perhaps a pot of boiling water, and soaking the platter inside?

Location: Jerusalem

My B&O Icons:

Beoremote-Beo4.png Beoremote-Beo4.png
Beovox.png Beovox.png
Beomaster.png Beomaster.png
Beogram-400x.png Beogram-400x.png
Electronics Technician in Jerusalem Israel. B&O fan for over 50 years.
Mark-sf
Mark-sf
Bronze
592 posts
Posted June 16, 2022 at 00:55 GMT
#692380
Based upon Beolover’s sample, that separation was caused by force. Note that there is thin film residue to the old bond indicating that a shear force will likely be more successful than heat softening. This would call for a non-marring mallet with the platter supported thru the center hole. You could also try a .1mm stainless steel spudger to work around the edge to break the bond.
or
BeoWorld Gold Membership card
Join BeoWorld

Register to access the forums, reference material, and exclusive member benefits — including our monthly prize draw.

Become a Member

December 2026 Prize Draw

Gold Members Only

As a Gold member you're automatically entered into our exclusive prize draw — your chance to win iconic Bang & Olufsen products. A unique benefit of BeoWorld Gold membership, every draw brings a new opportunity to win something special.

View Prize Go For Gold
BeoSound Level

1st Prize

BeoConnect Core

2nd Prize

BeoRemote Halo

3rd Prize